Metal Tab on all Medium Blades

This ultrasharp blade consists of a 440C stainless-steel lower blade and an extremely fine ceramic upper blade with ultrasophisticated titanium coating. The ceramic guarantees a low heat transfer and less friction, allowing longer and faster clipping while reducing the risk of clipper burns and preventing skin irritation.

Thanks to the brand-new technology used to coat the ceramic with titanium, the blade will stay sharp much longer than regular blades. This way you will be able to enjoy your clipping equipment longer!  Thanks to the lever at the bottom of the blade, you can adjust and choose between 5 different clipping lengths: 0.5 mm, 1 mm, 1.5 mm, 2 mm and 3 mm.

This blade is compatible with the Wahl 5in1 Snap on Combs and are available in medium and fine.

Benefits

• Adjustable cutting lengths: 0.5 mm (#30), 1 mm (#15), 1.5 mm (#10), 2 mm (#9) and 3 mm (#8)
• Material upper blade: 440C stainless steel
• Material lower blade: ceramic with titanium coating
• Compatible with the Show Tech Experto, Wahl Arco, Wahl Bravura, the Wahl Chromado, the Wahl Creativa the Wahl Figura, the Wahl Motion and Wahl Super Groom clippers

 Use instructions

BLADE REMOVAL

• Hold the clipper face up with one hand and press down on the teeth at the top of the blade using your thumb until the blade it is unclicked. Hold out your other hand and use it to catch the blade and to avoid dropping it.

BLADE INSTALLATION

• Hold the clipper face down with one hand and align the bottom of the blade with the middle of the recess at the back of the clipper. Make sure that the lever at the bottom of the blade comes over the clipper. Push the centre and upper part of the blade down until it snaps into place.

BLADE CLEANING AND OILING

• Cleaning – Press and hold the top of the blade. Use the cleaning brush to remove hair from between the upper and lower blades.  A can of compressed air also helps remove extra hair between upper and lower blades.
• Oiling –  Use 1 to 2 drops of the lubricating oil on the blade starting on each side and middle of blade.  Run blade to move the oil completely over the surface.
  Note: Do not detach the blade spring while maintaining to avoid malfunctioning.